Tippmann Model  98 Custom  MODs / Ups
 
 
     
Just about any of the products you see me using can be purchased  in my eBay Store.
     
 

 
 

Parts Used Marker in Modification

  • Ops Gear G36 Fixed Stock

  • Ops Gear G36 Barrel

  • Tippmann X7 Carry Assault Handle

  • Orange Delran forward Bolt

  • Picatinny rail Composite

  • Spec Ops Delta Ring

 

  • Bossman Magazine Kit

  • DuraCoat Matte Black Gun Finish

  • M4 Hand guard

  • FAB Laser Mount

  • Beam Shot Laser

  • FAB Dual Fore grip Picatinny mount

  • Ergonomic Vertical grip

 
     

  I began with a nice 98 I picked up on eBay. I stripped it down then began with the milling. I smoothed the casting seams, cut off the rear sight, milled down the lettering on the left side a little. I filled the note that is stamped on the right hand receiver.

 
     
Then I milled off the Dove tail along the top of the receiver.  I cut a piece of picatinny stock to fit the length of the top rail. I located, drilled and tapped four mount screw holes. Next I added some picatinny stock to the left side of the magazine well.
     
I stripped the paint from the receiver and the magazine well, in preparation for the finish. This was also a good time to polish the internal bolt slide areas.   
     
Then I applied a few good coats of DuraCoat to the Receiver and mag. well.
     
Next was reassembly after the finished dried.
     
Here is one version of it finished I am waiting for another stock and barrel. This should work well for a Close Quarters Marker as it is now.
     
Here is the complete marker. It is ready for a new owner. This is one sweet Marker. We can ship it as is or beef it up with changes or additions.
     

A Steel at $495.00 as is ready to rock.

  
     
     
     
     
     
BT-4 Tippmann A-5 Tippmann Model 98 Custom